-20%
, ,

SC Standard Air Cylinder Bore 80/100/125mm Double Acting Pneumatic Piston Cylinder Tools 25/50/75/100/200/500/800/1000mm Stroke

Availability:

999 in stock


7,911.00৳ 49,196.00৳ 

Stroke 1000mmStroke 100mmStroke 125mmStroke 150mmStroke 175mmStroke 200mmStroke 250mmStroke 25mmStroke 300mmStroke 350mmStroke 400mmStroke 450mmStroke 500mmStroke 50mmStroke 600mmStroke 700mmStroke 75mmStroke 800mmStroke 900mm
BORE 100mmBORE 125mmBORE 80mm
Clear
Compare

Please note that:

When the cylinder stroke of SC/SU/SCJ exceeds 400mm, and the cylinder stroke of MAL/MA/MAJ exceeds 450mm, Russian customers should choose the transportation mode of CAINIAO STANDARD HEAVY.

Because the total length of the cylinder exceeds 600mm, this length does not meet the requirements of other transportation methods.

Thanks you for your understanding!

Product Feature:
1. Standard cylinder.
2. The seal of pston adopts heterogeneous two way seal structure. It's dimension is tight and it has the function of grease reservation.
3. It is tie rod cylinder. the cylinder barrel and front/rear cap is jointed by tie rods with high reliability.
4.Compared with ISO15552 Standard cylinder,SC series cylinder with the same bore size is shorter.
5.The buffer adjustment of cylinder is smooth and steady.
6. Cylinders and mounting accessories with several specifications are optional.
7.The seal material with high temperature resistance is adopted,operating temperature range is 0~150℃.

Installation and application:

1. When load changes in the work, the cylinder with abundant output capacity shall be selected.

2. Relative cylinder with high temperature resistance or corrosion resistance shall be chosen under the condition of high temperature or corrosion.

3.Necessary protection measure shall be taken in the environment with higher humidity, much dust or water drops, oil dust and welding dregs.

4.Dirty substances in the pipe must be eliminated before cylinder is connected with pipeline to prevent the entrance of particles into the cylinder.

5.The medium used by cylinder shall be filtered to 40um or below.

6.Anti-freezing measure shall be adopted under low temperature environment to prevent moisture freezing.

7. The cylinder shall be carried out test run without load before application. prior to run, buffer shall be turned to the minimum and gradually released to avoid the damage on cylinder caused by excessive impact.

8. The cylinder shall avoid the influence of side load in operation to maintain the normal work of cylinder and extend the service life.

9. If the cylinder is dismantled and stored for a long time, please conduct anti-rust treatment to the surface. anti-dust caps shall be added in air inlet and outlet ports.

window.adminAccountId=2674083623;

Reviews

There are no reviews yet

Add a review
You must be logged in to post a review Log In

Q & A

There are no questions yet

Ask a question

Your question will be answered by a store representative or other customers.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Thank you for the question!

Your question has been received and will be answered soon. Please do not submit the same question again.

Error

Warning

An error occurred when saving your question. Please report it to the website administrator. Additional information:

Add an answer

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Thank you for the answer!

Your answer has been received and will be published soon. Please do not submit the same answer again.

Error

Warning

An error occurred when saving your answer. Please report it to the website administrator. Additional information: